University of Maryland Physics Education Research Group


Alternative Homework Assignment: Hoover Dam

PERG Info | PERG materials | PERG HOMEPAGE | PER on the web | Resources on the web

Alternative Homework Assignment: Hoover Dam

Hoover Dam has been supplying a portion of the southwest's electrical power since 1935. A project completed in 1993 modernized the Dam's power plant and greatly increased it's output to approximately 2000 Megawatts. The object of this problem is to design a portion of this modernization project. The task is to take the energy stored in the gravitational potential energy of the water in Lake Mead, and make it available as electricity for use in an industrial center in the vicinity of LA, nearly 300 miles away.

  1. At the base of the Dam's 726 foot tall wall, there are 17 generators. These generators are powered by water that falls down 220 m shafts onto turbines which turn the generators. What volume of water must fall in each second in order to power one of the generators?
  2. This generator consists of a coil of wire with a radius of 1m which is rotated by the turbine at a rate of 60 Hz. The coil is in a 0.1 T magnetic field which induces an AC EMF in the coil. If this generator produces an RMS voltage across its terminals of 16,500 V, how many turns of wire should the coil have?
  3. The generator is attached to a transformer which steps up the voltage for transmission. If the generator is producing its maximum power, what is the impedance across the transformer?
  4. The power from this generator is to be transmitted to LA via a copper cable that is 5cm in diameter. If this cable is to be 300 miles long, what is the total resistance across this cable?
  5. In LA, the cable will connect to another transformer which will step the voltage down to a level that the factories in the industrial center can use. The power delivered by this transformer will be proportional to the voltage drop across its primary coil. This means that in order to be as efficient as possible, the impedance across the transformer must be large compared to the resistance in the cable. What impedance must the transformer have if the voltage drop across the cable is to be less then the voltage drop across the cable and transformer combined by a factor of 108?
  6. How much power is dissipated by the resistance in the cable?
  7. What is the minimal integer number of turns the transformer at the Dam needs to have in each of its coils in order to accomplish this change in voltage?
  8. For industrial use, it is convienient to have power available in voltages greater than 120 V. For this reason, the standard voltage for industrial use is 66,000 V. What is the minimal integer number of turns it needs to have in each of its coils, in order to step the transmission voltage down to this level?
Work supported in part by NSF grant DUE-9455561

These problem written and collected by K. Vick, E. Redish, and P. Cooney. These problems may be freely used in classrooms. They may be copied and cited in published work if the Activity-Based Physics (ABP) Alternative Homework Assignments (AHA's) Problem sight is mentioned and the URL given.

To contribute problems to this site, send them to

Go back to the AHA page

Information about PERG Resource materials from PERG PERG Homepage PER elsewhere on the web Resource materials for teachers

Maintained by University of Maryland PERG
Comments and questions may be directed to E. F. Redish
Last modified June 25, 2002